Your browser is not supported

You are using a browser we do not support any longer. To continue visiting our website, please choose one of the following supported browsers.

Our global presence

Please select a business area and your country and language.

Close

Not quite sure about what you are looking for?

Use the links below to jump directly to the most searched topics

How to set up my air line correctly

After all, pneumatic tools need air to work!

April 23, 2019

There are 3 simple steps to make sure your air line installation is providing the right pressure and that your accessories selection is correct, so you can ultimately work productively. It does not take long and it is something you can easily do yourself using our self-diagnostic checklist.

expert-article - How-to-set-up-my-air-line-correctly - overview

3 steps to check that your air line is set up correctly: it’s as easy as 1, 2, 3…

expert-article How-to-set-up-my-air-line-correctly graphics-steps-LARGE1

Step 1: Calculate if there is an air pressure drop between the FRL and the tool.

  • First, read the FRL gauge value
  • Secondly, measure the dynamic pressure at the tool’s inlet
  • Then, calculate the difference between the two values to see if there is a drop in air pressure between the FRL and the tool

Annabelle Bray - expert corner - head zoom

In the air tool installation, most of the pressure drops occur between the pipe-end and the tool

Annabelle BRAY , Global Product Marketing Manager Accessories
expert-article How-to-set-up-my-air-line-correctly graphics-steps-LARGE2

Step 2: Identify where pressure is being lost by checking that your accessories have been selected and installed properly.

There are various points to inspect, the main ones being: at the tool inlet, the couplings/nipples and hose connections, as well as the FRL. To avoid pressure drops you want to make sure that:

  • Accessories have the correct diameters and thread sizes/types 
  • The hose is not longer than needed
  • Clamps are properly tightened

expert-article How-to-set-up-my-air-line-correctly graphics-steps-LARGE3

Step 3: Final measurements and adjustments.

Once you are confident that all accessories have been selected & installed correctly, measure once more the dynamic pressure at the tool’s inlet. You can then adjust accordingly the FRL regulator to ensure you get a reading of 90 psi / 6.3 bars at the tool inlet.

Annabelle Bray - expert corner - head zoom

When it comes to air pressure, higher isn’t always better!

Annabelle BRAY , Global Product Marketing Manager Accessories